HP Draftmaster "X axis Failure" HELP!!

HP Draftmaster "X axis Failure" HELP!!


[ Follow Ups ] [ Post Followups ] [ FAQ ]
[ Back to Messages ]

Posted by George Manship on January 29, 2002 at 02:41:32:

I have recently bought the HP Draftmaster RX 7596B plotter and in order for me to get it up the stairs I had to bravely dismantle it.
I assembled it back together exactly and then fired it up, it moved a little and made a noise then it displayed ugly error message, "X axis failure" see manual. Unfortunetly I have no manual, after some investigation I found out it could be a defective motor encoder or PCA/analogue board. The only response I have from it is the pen stepper motor move about 5 steps.

: If you could offer some advice on how to get round this I will be most gratefull.

: Regards

: George


Follow Ups:


Post a Followup

Please note:
  • Messages must be on the topic of this forum!
  • No posting of requests for cracks, codes, serials, or warez!
  • No posting of illegal software or links to such sites!
  • No use of profanity or inappropriate or offensive language!
  • Spamming is not allowed!
  • We track the IP addresses of forum abusers!
  • Abuse of this forum will be reported to your ISP!
Name:
E-Mail (optional):
please note: your e-mail address will be visible in your message.

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL: