Re: Micropolis 2112 jumper settings

Re: Micropolis 2112 jumper settings


[ Follow Ups ] [ Post Followups ] [ FAQ ]
[ Back to Messages ]

Posted by Bob on May 17, 2000 at 16:48:32:

I am upgrading an old Mac in my office that currently has 2 500MB drives inside. There are 2 Micropolis 2112 drives here I am going to use that were part of a RAID set-up so I know there are some jumpers that will need to be changed. One of the drives will be SCSI I.D. 0, and the other will be SCSI I.D. 1. According to the specification sheet I downloaded from: http://www.mm.mtu.edu/drives/micropolis/scsi/2112spec.txt there are two SCSI I.D. areas. Also, one drive has a jumper in the W10-W11 area, and one has a jumper on the Spin0 pins. Both have a jumper on the W3 pins.

Thanks for any help.


Follow Ups:


Post a Followup

Please note:
  • Messages must be on the topic of this forum!
  • No posting of requests for cracks, codes, serials, or warez!
  • No posting of illegal software or links to such sites!
  • No use of profanity or inappropriate or offensive language!
  • Spamming is not allowed!
  • We track the IP addresses of forum abusers!
  • Abuse of this forum will be reported to your ISP!
Name:
E-Mail (optional):
please note: your e-mail address will be visible in your message.

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL: