Drive defaulting to PIO not UDMA100

Drive defaulting to PIO not UDMA100

[ Follow Ups ] [ Post Followups ] [ FAQ ]
[ Back to Messages ]

Posted by Steven Roussey on March 29, 2002 at 00:07:42:

I have a new shuttle KT266A mainboard (BIOS set to use UDMA100), a 80pin cable correctly connected, WinXP (the Device Manager Primary Channel set to use DMA if available, but says using PIO mode), and a Quantum Fireball AS 40 drive (only jumper is set to use CS -- cable select -- which is Master).

While it is a newer drive, it used to be used in an old system. Is it using PIO still because it was formatted in such a manner on that older system?

Follow Ups:

Post a Followup

Please note:
  • Messages must be on the topic of this forum!
  • No posting of requests for cracks, codes, serials, or warez!
  • No posting of illegal software or links to such sites!
  • No use of profanity or inappropriate or offensive language!
  • Spamming is not allowed!
  • We track the IP addresses of forum abusers!
  • Abuse of this forum will be reported to your ISP!
E-Mail (optional):
please note: your e-mail address will be visible in your message.



Optional Link URL:
Link Title:
Optional Image URL: