Re: Conner hard drive

Re: Conner hard drive


[ Follow Ups ] [ Post Followups ] [ FAQ ]
[ Back to Messages ]

Posted by Wonderful on April 06, 2000 at 14:47:19:

In Reply to: Conner hard drive posted by Wendel on April 05, 2000 at 14:45:53:

: I have a Conner CP30104/H hard drive and want to jumper it as Primary drive, but don't know the pinout on it. It has a row of pins similar to this:
: [..]˚:::: :: on the end opposite the drive cable. Are these the pinouts? The setup says to jumper DSP makes it master and allows a slave on the cable. Where are these pins and what is DSP?
: Thanks; If you post, email me, too, as I need this ASAP.
Answer: The jumper block is on the bottom side of the drive. Jumpering the two left-most sets of pins (with pin block at bootom view) will set the drive to Master of two drive setup. However, this only works with hard drives, and I have not tried it with a CD-ROM.
: wendell.m@usa.net




Follow Ups:


Post a Followup

Please note:
  • Messages must be on the topic of this forum!
  • No posting of requests for cracks, codes, serials, or warez!
  • No posting of illegal software or links to such sites!
  • No use of profanity or inappropriate or offensive language!
  • Spamming is not allowed!
  • We track the IP addresses of forum abusers!
  • Abuse of this forum will be reported to your ISP!
Name:
E-Mail (optional):
please note: your e-mail address will be visible in your message.

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL: