Re: Henry help me please!

Re: Henry help me please!

[ Follow Ups ] [ Post Followups ] [ FAQ ]
[ Back to Messages ]

Posted by Drewpy on February 17, 2002 at 16:09:47:

In Reply to: Re: Henry help me please! posted by Henry on February 17, 2002 at 13:49:28:

: : Henry,I went and bought the ide controller card for the gemlight system we spoke about earlier.This worked fine to get the hard drive formatted but now in fdisk it doesn't detect the cd-rom hooked up to the same damn card!!!I don't understand this because if in fdisk the card makes the system list and recognize and access the HD(i have a c:prompt after the format)why would it detect and list the cd-rom(it even lists the right model number during loading the ide card)why then in fdisk will it not detect it when i try and start with cd-rom support????Am i doing something wrong?(besides messing with this old piece of crap!)I even tried to slave the cdrom(yes i put the jumper to slave position) off this HD thinking that maybe the cable was bad (but i doubted it since the ide card listed it when it loads)and it did the same thing.I even tried a different cd-rom(mine in my current system)with the same results.I'm pulling my hair out here.Any help is greatly appreciated.Thank You in advance,Drewpy
: fdisk is a fixed disk partitioning utility. It does not support, see or care about removable media devices.

: Sounds like the IDE card sees the CD so the OS should see it as well if you have the right drivers installed. If you have the CD on the cable with the HDD the CD should be "slave". If the CD is on a separate cable (IDE port) it can usually be set EITHER master or slave but some devices are picky so you may need to experiment.

: Suggest that you put a CD in the drive and try to see the files.

: Good Luck,
: Henry

Henry,I tried to go to the e: prompt and see the win98 install disk and it says invalid drive specification.I know fdisk is for partitioning and formatting fixed disk drives,but at the start it gives you an option to start with or without cdrom support.Ive tried both ways and the system will not see the cd-rom drive.I can try and force the proper drivers into the system in DOS but this will do no good if the MB doesn't see the drive will it?Drewpy

Follow Ups:

Post a Followup

Please note:
  • Messages must be on the topic of this forum!
  • No posting of requests for cracks, codes, serials, or warez!
  • No posting of illegal software or links to such sites!
  • No use of profanity or inappropriate or offensive language!
  • Spamming is not allowed!
  • We track the IP addresses of forum abusers!
  • Abuse of this forum will be reported to your ISP!
E-Mail (optional):
please note: your e-mail address will be visible in your message.



Optional Link URL:
Link Title:
Optional Image URL: