Re: Please help with flashing Bios in Asus P2B

Re: Please help with flashing Bios in Asus P2B


[ Follow Ups ] [ Post Followups ] [ FAQ ]
[ Back to Messages ]

Posted by Henry on October 21, 2001 at 19:03:14:

In Reply to: Re: Please help with flashing Bios in Asus P2B posted by jorgemac on October 19, 2001 at 12:43:25:

: My EPROM chip is 28F010 that should be reprogram in 12V, i think. But the problem is ¿WHERE is the jumper to change de bios chip from 5V to 12V??
: I revised the manual of this matherboard and the Asus Web and I don´t find it.
: Thanks for your help.


On some boards I have seen there was a 3-pin header with 12V at one end, 5V at the other. A standard jumper normally connected the middle and 5V pins. This header, if it exists would most likely be near the BIOS chip; it might have a colored jumper instead of a black one - you may need to inspect your board very closely to find it.

Can Asus Tech Support tell you anything?

Good Luck,
Henry



Follow Ups:


Post a Followup

Please note:
  • Messages must be on the topic of this forum!
  • No posting of requests for cracks, codes, serials, or warez!
  • No posting of illegal software or links to such sites!
  • No use of profanity or inappropriate or offensive language!
  • Spamming is not allowed!
  • We track the IP addresses of forum abusers!
  • Abuse of this forum will be reported to your ISP!
Name:
E-Mail (optional):
please note: your e-mail address will be visible in your message.

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL: