RE: Vtech/PCpartner Mother boards

RE: Vtech/PCpartner Mother boards

[ Follow Ups ] [ Post Followups ] [ FAQ ]
[ Back to Messages ]

Posted by Robert on April 20, 2000 at 11:17:27:

I have just recently had to change my motherboard and I have bought a PCPartner motherboard, Model Code No. - 35892801XX, chipset nš VT82C693.

The instalation of the motherboard was done by the reseller. The computer is working, but after reading the technical reference booklet for
the motherboard, I noticed that the jumpers on my board are all set to default, I spoke to the reseller where they assured me that thats the way they set up the PC, I read in the booklet that if jumper JP7 exists on the motherboard, the jumper should be set differently to each CPU installed.

My CPU is a Celeron 300A, and I dont know exactly how I should set the jumper as I dont understand how the ratio of system works.

The default setting for JP7 is Ratio of System = 2, so what is the Ratio of System for a CPU equivalent of Celeron 300A.?
and how should I set up the system bus frequency for jumpers JP1 and JP2?

I would be very grateful if I received a response,

Thank You
Roberto Pacheco

Follow Ups:

Post a Followup

Please note:
  • Messages must be on the topic of this forum!
  • No posting of requests for cracks, codes, serials, or warez!
  • No posting of illegal software or links to such sites!
  • No use of profanity or inappropriate or offensive language!
  • Spamming is not allowed!
  • We track the IP addresses of forum abusers!
  • Abuse of this forum will be reported to your ISP!
E-Mail (optional):
please note: your e-mail address will be visible in your message.



Optional Link URL:
Link Title:
Optional Image URL: